01-13-2017, 09:42 PM
(This post was last modified: 01-13-2017, 10:02 PM by Florida Fish Hunter.)
I updated my anchor trolley setup today utilizing pulleys that I made with my 3d printer. No holes drilled in the kayak or screws required for this setup. The trolley line moves easily so all that remains now is a outdoor functional test...
I am still amazed how much enjoyment I get out of creating things with my 3d printer.
![[Image: pulley1.JPG]](http://www.needfulthings.net/tulsaturbo/kayak/pulley/pulley1.JPG)
![[Image: pulley2.JPG]](http://www.needfulthings.net/tulsaturbo/kayak/pulley/pulley2.JPG)
![[Image: pulley3.JPG]](http://www.needfulthings.net/tulsaturbo/kayak/pulley/pulley3.JPG)
![[Image: pulley5.JPG]](http://www.needfulthings.net/tulsaturbo/kayak/pulley/pulley5.JPG)
Rear pulley mounted...
![[Image: pulley6.JPG]](http://www.needfulthings.net/tulsaturbo/kayak/pulley/pulley6.JPG)
Front pulley mounted...
![[Image: pulley7.JPG]](http://www.needfulthings.net/tulsaturbo/kayak/pulley/pulley7.JPG)
I am still amazed how much enjoyment I get out of creating things with my 3d printer.
Rear pulley mounted...
Front pulley mounted...